Preparing for use
R&S
®
SMCV100B
21
Getting Started 1432.7046.02 ─ 04
●
Ensure that the network settings comply with the security policies of your com-
pany. Contact your local system administrator or IT department before con-
necting your product to your company LAN.
●
When connected to the LAN, the product may potentially be accessed from
the internet, which may be a security risk. For example, attackers might mis-
use or damage the product.
To connect to LAN
The connector is located on the
► Connect the LAN socket via an RJ-45 cable to the LAN.
By default, the R&S
SMCV100B is configured to use DHCP (dynamic host config-
uration protocol) and no static IP address is configured.
If switched on and connected to the LAN, the R&S
SMCV100B displays the
address information on the screen.
Figure 4-1: IP address indication on the screen (example)
See also the chapter "Connecting the Instrument to the Network (LAN)" in the
user manual.
4.8
Connecting a monitor
This section describes how to connect a monitor for direct operation of the
R&S
SMCV100B. You can skip the following procedure, if you only operate the
R&S
SMCV100B remotely.
The connector is located on the
► Connect the monitor to the DVI-D socket.
You can connect the following types of monitor sockets:
● DVI-D: Connect it to the DVI-D socket.
DVI-A: not supported
DVI-I: not supported
Connecting a monitor
