Preparing for use
R&S
®
SMCV100B
20
Getting Started 1432.7046.02 ─ 04
●
Always terminate open cable ends.
●
Ensure that connected external devices comply with EMC regulations.
●
Use the cable R&S
DIGIQ-HS for connection to the Dig. IQ HS x interfaces of
the instrument. The cable is available under material number 3641.2948.03.
How to:
Chapter 4.12, "Connecting to Dig. IQ HS x"
●
Use an SFP+ to RJ-45 adapter and an RJ-45 cable for connection to the IP
Data interface of the instrument. We recommend that you use the adapter
"FCLF850P2BTL" from Finisar available under material number
3627.0570.00.
How to:
Chapter 4.13, "Connecting to IP Data interface"
Signal input and output levels
Information on signal levels is provided in the data sheet. Keep the signal levels
within the specified ranges to avoid damage to the R&S
SMCV100B and connec-
ted devices.
4.6
Connecting to power
For safety information, see
1. Plug the AC power cable into the AC power connector on the rear panel of the
instrument. Only use the AC power cable delivered with the R&S
SMCV100B.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
4.7
Connecting to LAN
Network environment
Before connecting the product to a local area network (LAN), consider the follow-
ing:
●
Install the latest firmware to reduce security risks.
●
For internet or remote access, use secured connections if applicable.
Connecting to LAN
