Remote control commands
R&S
®
NGU
138
User Manual 1179.2531.02 ─ 03
Parameters for setting and query:
<Channel list>
<list>
Example:
OUTP:TRIG:STAT 1
OUTP:TRIG:BEH ON
Example:
OUTPut:TRIG:BEH? (@1)
Queries output behavior of trigger event at channel 1.
7.5.7
Ranges / DVM / PLC setting
The DVM and range settings are available only with R&S NGU201 model equipped
with R&S NGU-K104 (P/N: 3663.0390.02).
The
SOUR:VOLT:DVM
contains commands for activating the DVM function.
The
SENSE:CURR:RANG
and
SENSE:VOLT:RANG
contains commands for setting the
voltage range and current range of the measurements.
All these commands require
*OPC?
at the end of the command execution.
................................................................................... 138
SENSe:CURRent:RANGe:AUTO:DOWN:MINimum
........................................................... 139
SENSe:CURRent:RANGe:AUTO:DOWN:THReshold
.........................................................139
SENSe:CURRent:RANGe:AUTO:UP:APPRoach
...............................................................139
SENSe:CURRent:RANGe:AUTO:UP:THReshold
.............................................................. 140
..................................................................................... 140
...................................................................................140
......................................................................................141
................................................................................... 141
[SOURce:]VOLTage:DVM[:STATe]
<arg0>[, <Channel list>]
[SOURce:]VOLTage:DVM[:STATe]?
[<Channel list>]
Sets or queries digital voltmeter measurements.
Parameters:
<arg0>
1
Enables digital voltmeter measurement.
0
Disables digital voltmeter measurement.
Parameters for setting and query:
<Channel list>
<list>
Example:
VOLT:DVM 1
MEAS:VOLT:DVM?
-> 1.000E+00
Enables and returns digital voltmeter measurement.
Example:
VOLT:DVM? (@1)
Queries DVM state at channel 1.
Configuration commands
