60/118
This document and the information contained herein, is the exclusive property of R&M Materials Handling Inc. and represents a non-public, confidential and proprietary trade
secret that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials
Handling Inc. Copyright 2020 © R&M Materials Handling Inc. All rights reserved.
7.3.1
Checks to be performed by the operator
1
Check the general condition
of the hoist.
2
Visually check the
operating environment to
make sure that there are
no new hazards which
might prevent the safe
use of the product.
3
Visually check to see if there
are any oil leaks from the
product.
4
Visually check the chains
for any deformation,
damage or twists. Check
the chain for cleanness
and correct lubrication
according to the
instructions given in
chapter Lubrication.
5
Inspect the load hook for
nicks, gouges, deformation of
the throat opening, wear on
the saddle or load bearing
point, and twisting. Also check
that the hook rotates freely.
6
Check that all warning
signs are in place, in good
condition, and can be
read easily. Refer to
chapter Signs.
7
Never operate the product if it
is locked or tagged out.
Follow the local safety
procedures.
8
Check that the emergency
stop button can be
pressed down and that it
will stay in that position.
9
Check the condition of the
pendant cable and the
retaining wire: Check that
there are no damages and
that no wires are coming out.