50/118
This document and the information contained herein, is the exclusive property of R&M Materials Handling Inc. and represents a non-public, confidential and proprietary trade
secret that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials
Handling Inc. Copyright 2020 © R&M Materials Handling Inc. All rights reserved.
6.4
Test run without load
1
Electrical connections
Turn on the power to the hoist.
2
Controller
Check that the controller is correctly installed and in good condition. If you have a radio controlled
hoist,check that the radio controller does not cause any disturbance to other radio controlled
equipment. Check the functionality of the push buttons, joysticks, and switches.
Check that all motions occur to the correct direction. Make sure that desired functions occur when
operating the push button, joystick, or switch.
• Check that the hook movement corresponds to the controller direction by driving the hook
carefully in down direction. If the hook moves upwards, change the control direction by changing
the two phases in the power supply.
• Check that the traveling motion directions correspond to the controller directions.
3
Emergency stop button
Check the operation and condition of the emergency stop button.
NOTICE
Only use the emergency stop button to stop movement in the event of product
malfunction or other emergency situations. Using the emergency stop button can
cause the load to swing unexpectedly.
