Rain Master RME EAGLE, User Manual

Page: 10 / 168

Rain Master Irrigation Systems RME EAGLE User Manual
Chapter 2 Specifications Page 3
2.0 RME EAGLE SPECIFICATIONS
2.1 PROGRAMMING CAPABILITY
•
Four (4) independently controllable irrigation programs, with five (5) selectable start times,
for a total of 20 possible irrigation cycles per day.
•
Runtime(s) for each station can be set from 1 minute to 9 hours 59 minutes per station, in
one-minute increments.
•
Quick Station(s) programming to allow rapid programming of an entire block of stations, all
with the same runtime.
•
Water Days for each program can be based on a seven-day cycle or a skip-by-day cycle,
which allows a program to skip from 1 to 30 days between watering cycles.
The water days can be further restricted with the selection of ODD/EVEN calendar days.
•
Manually activated system Check/Syringe Cycle to sequentially run each station for a user
selectable time, with a range from one minute up to nine minutes.
•
Manually activated program cycle to execute a program independently of its programmed
start time and water days.
•
Manually activated station cycle to operate a single station for a selectable period of time
from 1 minute to 9 hours 59 minutes.
•
Programmable Master Valve to utilize and control a Master Valve on a per program basis.
•
Configurable Master Valve Type to select either a Normally Open Master Valve or a
Normally Closed Master Valve.
•
Programmable pump independent of the Master Valve on a per program basis.
•
Programmable stacking or non-stacking operation of the programs. In the event that
programmed start times either within a program or between programs should overlap, or
coincide, the controller can either be programmed to sequentially execute one program after
the other program has completed (Stack Mode) or to simultaneously execute all programs as
their programmed start times occur (No Stack Mode).
•
Programmable delay time between station executions. The programmed delay time can be
between 0 to 255 seconds (4 minutes 15 seconds). This capability allows slow-closing
valves to completely shut off, before the next valve turns on.
2.1.1 Water Conservation Features
•
Flow sensing and control.
•
Evapotranspiration (ET) based scheduling.
•
Percentage adjustment on a per program basis to allow an increase or decrease of all station
runtimes within that program. The percentage will allow adjustment from 0 to 300% in 1%
increments.