TX frequency**
Transmitting frequency. Format MHz.kHz.Hz. Step 5 or 6.25 kHz.
The value entered must be within the frequency tuning range of the product as follows:
RIPEX-368: 370–400 MHz
RIPEX-400: 400–432 MHz
RIPEX-432: 432–470 MHz
RX frequency**
Receiving frequency, the same format and rules apply.
Note
: By default, the TX and RX frequencies are locked together and change in one field is mirrored
in the other. If clicked, the lock is removed and different TX and RX frequencies can be entered.
RF power [W]**
List box: possible values
Default = 5 W
The range of values in the list box is limited to 2 W for high Modulation rates. 10 W is available only
for lower Modulation rates and only when the respective SW feature key is active.
Channel spacing [kHz]**
List box: possible values
Default = 25 kHz
The wider the channel the higher the posible Modulation rate.
Modulation rate [kbps]
•
Approval
List box: possible values
○
CE
Radio parameters meet ETSI EN 300 113-1 V1.6.2 (2009-11), ETSI EN 302 561 V1.2.1 (2009-
12) and FCC part 90
○
FCC
Radio parameters meet FCC part 90 CPFSK modulations have use approx. 20% higher frequency
deviation compared to CE, so the receiver sensitivity is approx. 1-2 dB better.
○
CE LBT
Radio parameters meet ETSI EN 300 113-1 V1.6.2 (2009-11) and ETSI EN 302 561 V1.2.1
(2009-12) parameters for LBT (Listen Before Transmitt) mode
•
Modulation rate [kbps]
List box: possible values
Default = 83.33|16DEQAM
Possible values in list box are dependent on the Approval set. The two highest rates are available
only when the respective SW feature key is active.
Higher Modulation rate provides higher data speed but they also result in lower receiver sensitivity,
i.e. lower coverage range. The reliability of communication over a radio channel is always higher
when using lower Modulation rate.
75
© RACOM s.r.o. – RipEX Radio modem & Router
Advanced Configuration
