Installation Guide
73
•
Once the variables are set, the restart is requested. It is recommended that you accept the restart
so that the Scalar DLC DAS-Client software works properly.
Step 4
After the configuration is complete, the Scalar DLC software is ready to accept commands from
a DAS client.
Installing the DAS Administration Utility
The connection settings must be entered during the installation of the
dasadmin
software. See
Figure 37
for
a firewall-based connection and see
Figure 38 on page 74
for a direct (firewall-free) connection.
Figure 37
DAS Client Connections Using Firewall
Property
Operation
Description
DAS Client
connection
Select
Not using firewall
should be selected if there is no firewall between the
client host and the Scalar DLC host.
Using DAS/ACI firewall
should be selected if a firewall exists between
the client host and the Scalar DLC host.
DAS/ACI
firewall
server name
Enter
Name of the PC where the DAS/ACI Firewall software is installed
(shown for
Using DAS/ACI firewall
selection only).
Port
Enter
The firewall port (shown for
Using DAS/ACI firewall
selection only).
Scalar DLC
server name
Enter
The Scalar DLC server name (shown for
Not using firewall
selection
only).
DAS Client
name
Enter
The default DAS Client name. Refer to
Table 14
on page 72.
ACI Media
type
Select
The default ACI media type. Refer to
Table 14
on page 72.
Summary of Contents for SDLC 2.7
