26
Configuring the Fibre Channel Subsystem
SCSI Configuration
The SCSI configuration selection allows you to change the Initiator SCSI ID as well as to add or remove a
target SCSI ID.
SCSI Configuration Menu
Build Level: a9802
Current SCSI Configuration:
Initiator SCSI ID: 7
Target SCSI ID(s):
Reset SCSI Bus on Boot: Yes
SCSI Initial Discovery Delay: 15000 ms
1) Change Initiator SCSI ID
2) Add Target SCSI ID
3) Remove Target SCSI ID
4) Toggle SCSI Reset Operation
5) Change Discovery Delay Time
X) Return to previous menu
This menu displays:
the current SCSI Initiator ID
a list of the current SCSI Target IDs
the current value of the SCSI bus reset flag
a menu of valid SCSI configuration operations.
The operations to change these values are described below.
Change Initiator SCSI ID.
The
Initiator SCSI ID is the ID of the SCSI device that requests an operation to
be performed. To change the initiator SCSI ID:
Note
In any case
, do not enter Target SCSI IDs. It should not be
necessary to change the Initiator SCSI ID setting.
1.
Press
1
while in the SCSI Configuration Menu. The Configuration Menu displays the following prompt:
Enter new Initiator SCSI ID >
2.
Enter the new SCSI Initiator ID. The Configuration Menu accepts values between 0 and 15. The Scalar
218FC allows a target to have more than one ID.
3.
After specifying your new SCSI Initiator, press
Enter
.
If you specify an invalid value, the Configuration Menu displays the following message:
ERROR:
Summary of Contents for Scalar 218FC
