Quantum PowerStor L200, User Manual

Page: 62 / 112

Chapter 4 Using the Library
Using Tape Cartridges
46 Quantum|ATL PowerStor L200 Series Library User’s Guide
Unloading a
Cartridge
4
To unload a cartridge from the tape drive:
1
Press
Se
lect until the message EJECT/UNLOCK? is displayed.
2
Press Next to display the message Eject Cartridge?.
3
Press Enter to display the message Eject Cartridge? Eject
Drive?.
4
Press Enter to display one of the following messages:
• Drive is Empty (there is no cartridge to unload in the drive)
• Drive NOT Present (there is no cartridge to unload in the
drive)
• Eject to Slot 0?
5
Press Enter to unload the cartridge.
The library returns the tape cartridge to its original slot. You
cannot choose to send the cartridge to a different slot.
After the tape cartridge is unloaded, Library Idle is displayed
on the OCP.
6
Press Select to return to the main menu.
Using the Cleaning
Cartridge
4
If the tape drive detects a failure during the calibration routine or if
an unrecoverable hard error occurs while writing or reading a
tape, the message
Cln
is displayed on the OCP. This message
indicates that the drive head may be contaminated and in need of
cleaning.
Note: Always use the cleaning cartridge to clean the drive. Do
not use cleaning solvents or attempt to service the tape
drive head.