Quantum PowerStor L200, User Manual

Page: 33 / 112

Chapter 2 Installing the Library
Connecting the Library
Quantum|ATL PowerStor L200 Series Library User’s Guide 17
3
Connect the other end of the short SCSI cable to the tape drive
SCSI connector closest to library controller.
4
If the is a stand-alone external SCSI device, install the SCSI
terminator in the connector at the far left (looking at the back of
the library). Verify that the SCSI bus is terminated properly.
Figure 10 SCSI
Cabling stand-alone
Connection Scenario
5
Connect one end of the long SCSI cable supplied with the
library to the SCSI connector closest to the power switch on the
back of the library. Connect the other end of this cable to the
host’s SCSI adapter connector.
6
Secure the cables, using the wire cable clamps or screws
provided.
7
Connect the power cord to the power connector on the back of
the library (see
figure 9 ).
8
Connect the other end of the power cord to the site power.
Note:
Depending on the system configuration, the SCSI bus
initiates at the host, connects to the library controller,
then to the tape drive, and then to any other SCSI
devices on the bus. It must be terminated at the last
SCSI device on the bus (see
figure 10 ).
Host
SCSI cable to next SCSI
Library Controller
Drive (SCSI ID 1)
Supplied SCSI cables
Library (Top)
(SCSI ID 0)
device (or install the
supplied teminator)