Quantum PowerStor L200, User Manual

Page: 32 / 112

Chapter 2 Installing the Library
Connecting the Library
16 Quantum|ATL PowerStor L200 Series Library User’s Guide
Connecting the Library
2
Complete the following procedure to connect the power cord and
SCSI cables to the library (see
figure 9 ).
Figure 9 Rear Panel
Cable Connectors
To connect the library:
1
Verify that the library’s power switch is in the off position. It is
not necessary to power down the host.
2
Connect one end of the short SCSI cable supplied with the to
the library controller’s SCSI connector closest to the tape drive
(see
figure 10 ).
Caution: Verify that the library controller is connected to the
same type of SCSI bus as the drive on that bus. For
example, connecting a single-ended SCSI library to a
differential SCSI adapter will cause a host system
malfunction.
Power switch
Power connector
Power supply
SCSI connectors
(library controller)
Serial port
(FSE use only)
Tape drive assembly
Connect to a
SCSI device
(or install
terminator)
Connect
together
Connect to
host