![background image](http://html1.mh-extra.com/html/quantum/lto-5-hh-sas-c/lto-5-hh-sas-c_technical-reference-manual_3541232054.webp)
Chapter 4: Operations
Diagnostic and Maintenance Functions
48
Quantum LTO-5 HH SAS Model C User’s Guide
• If the update completes successfully, the tape drive rewinds and
unloads the FUP tape, resets itself, and is ready to use the new
firmware. The drive automatically reboots.
• If the update fails, the tape drive posts an error code to the SCD.
To determine the error, locate the code in
. Push the Unload Button to eject the
cartridge. The drive exits Maintenance Mode after the cartridge
is removed. Contact Quantum Technical Support for problem
determination or machine replacement.
Function Code 3: Create
FUP Tape
Function Code 3 copies the drive's firmware update (FUP) data to a
scratch data cartridge. The resulting FUP tape can only be used to
update the firmware on other LTO Gen 5 tape drives with the same host
interface (SAS, or Fibre Channel).
Caution:
For this function, insert only a scratch (blank) data
cartridge or a cartridge that may be overwritten. During
the test, the drive overwrites the data on the cartridge.
Note:
If you inserted an invalid tape cartridge (e.g. Gen2 or WORM
media), error code J or 7 appears in the SCD. If you inserted a
write-protected cartridge, or the media has read-only
compatibility (e.g., Gen3 media), error code P appears in the
SCD. In either case, the tape drive unloads the cartridge and
exits Maintenance Mode after the cartridge is removed.
1
Place the drive in Maintenance Mode. For instructions, see
2
Press the Unload Button once per second until 3 appears in the SCD.
(If you cycle past the desired code, press the Unload Button once
per second until the code reappears.)
3
Press and hold the Unload Button for three or more seconds, then
release it to select the function. The SCD changes to a flashing C.
4
Insert a scratch (blank) data cartridge that is not write protected (or
the tape drive exits maintenance mode). If the cartridge is not
inserted within 60 seconds, the drive will exit Maintenance Mode.
The SCD changes to a flashing 3. The tape drive copies the FUP data
to the scratch data cartridge.
Summary of Contents for LTO-5 HH SAS C
