Chapter 3: Installation
Connect Power
26
Quantum LTO-5 HH SAS Model C User’s Guide
Figure 6 Example of
connecting the SAS device to
two servers
4
Ensure the host adapter and the server are configured correctly for a
SAS bus operation. Refer to the host adapter and server
documentation for instructions.
Connect Power
1
Plug the power cord into the rear panel (see
then plug the other end into a grounded electrical outlet.
2
Power-on the unit by pressing the Power Button. The POST runs,
which checks all hardware except the drive head. During the POST,
the Single-character Display (SCD) flashes several segmented
characters. Each segmented character represents a test performed
1 Tape drive
4 SAS host adapter card
2 SAS connectors
5 Servers
3 SAS cables
Summary of Contents for LTO-5 HH SAS C
