![background image](http://html1.mh-extra.com/html/quantum/lto-5-hh-sas-c/lto-5-hh-sas-c_technical-reference-manual_3541232066.webp)
Chapter 4: Operations
Diagnostic and Maintenance Functions
60
Quantum LTO-5 HH SAS Model C User’s Guide
• If an error is detected, the Fault light flashes and the drive posts
an error code to the SCD. To determine the error, locate the
code in
Appendix A, Error Codes and Messages
. To clear the
error either turn the power off and then on again, or reboot the
drive by pressing and holding the Unload Button for 10
seconds.
Function Code L: Load/
Unload Test
Approximate Run Time = 25 seconds per loop
Total Number of Loops = 10
Function Code L tests the drive's ability to load and unload a tape
cartridge.
Press the Unload Button to stop the diagnostic and exit maintenance
mode. Pressing the Unload Button once will abort the test at the end of
the current test loop. Pressing the Unload Button twice will abort the
test immediately. Wait for the drive to rewind the tape and unload the
cartridge.
Caution:
Even though no data is written during this test, it is
recommended that you use a blank (scratch) cartridge for
this test.
1
Place the drive in Maintenance Mode. For instructions, see
2
Press the Unload Button once per second until L appears in the SCD.
(If you cycle past the desired code, press the Unload Button once
per second until the code reappears.)
3
Press and hold the Unload Button for three or more seconds, then
release it to select the function. The SCD changes to a flashing C.
4
Insert a scratch (blank) data cartridge. The SCD changes to a
flashing L and the tape drive runs the tests.
• If no error is detected, the diagnostic will loop and begin again.
To stop the loop, press the Unload Button for one second and
release. When the diagnostic ends, 0 temporarily appears in the
SCD, and the tape drive exits Maintenance Mode.
• If an error is detected, the Fault light flashes and the drive posts
an error code to the SCD. To determine the error, locate the
code in
Appendix A, Error Codes and Messages
. To clear the
Summary of Contents for LTO-5 HH SAS C
