![background image](http://html2.mh-extra.com/html/quantum/faststor-1/faststor-1_user-manual_3568628051.webp)
If you click on a slot, additional cartridge information is shown in a pop-up
window. This information includes the cartridge barcode (if label and barcode
reader are installed) and the error code.
Settings Pages
You can change the FastStor 1 configuration on the setting pages. These pages
can be accessed only by someone who is logged in as Administrator.
Personalization
On this page you can change the Remote Management passwords. To secure
your system, change both the passwords the first time you use the system. It is
possible to clear the remote management passwords via the front panel. Please
see The Maintenance Menus.
Here you may also turn on email event notification. When event notification is
enabled, the FastStor 1 sends warnings and errors by email to the recipient’s e-
mail address.
Network
On this page it is possible to change the IP configuration. See details in Remote
Management setup. The new configuration will take effect at next system reset.
Warning
: Please verify that the chosen settings are correct and consistent
before resetting the loader. Any mistakes must be corrected via the front panel.
SCSI-ID
On this page it is possible to change the SCSI-ID on your drive and loader. See
details in SCSI Setup.
Cleaning Options
By defining a cleaning slot, the FastStor 1 regards the cartridge in this slot as
the cleaning cartridge unless:
1.
another cartridge has previously been designated a cleaning
cartridge by the drive, or
2.
the loader contains a cartridge with a barcode label indicating it is
a cleaning cartridge.
Command Page
On this page it is possible to move cartridges between magazine slots and the
drive. All cartridges in the FastStor 1 can be found in a pull-down list sorted by
location. The other pull-down list shows the empty locations where it is possible
to move the cartridge.
FastStor 1 Installation and User Guide
45