Drive test
Starts a drive self test. (Only when supported by the
installed tape drive.)
Hardware test
Runs a test of the loader hardware, including the
Loader internal cabling.
Set Password
Item name
Description
Set Password
Allows the operator to set a four-digit password
protection for the menu system. The default password
is <0000>, meaning the password is disabled.
WARNING: If you set a password, make sure you do not forget it. If you do, it can only be
cleared with assistance from ADIC technical support or by a qualified service technician.
Cartridge Handling
Cartridge Slot Numbers
The cartridge slots have been given numbers as follows:
Left magazine: Slot 1, Slot 2, Slot 3 and Slot 4 (lowest number closest to the front)
Right magazine: Slot 5, Slot 6, Slot 7 and Slot 8 (lowest number closest to the
front)
Moving Cartridges to and from the Drive
The normal operations of the unit are controlled by the host software application.
When you must load or unload a specific cartridge using the control buttons on the
front panel, do the following:
To load a cartridge to the drive:
1. From the default display press the menu button and select
Load to Drive
from
the main menu. A screen picture like Figure 4.11 will be displayed. The
selected cartridge’s barcode is displayed in the bottom line.
Ok Cancel
Load to drive
From Slot:
1
35
3
4
Figure 4.11 Load to Drive
2. Select the slot number of your choice. The system ignores empty slots. Press
the
4
button to increment and the
3
button to decrement.
3. Press the Ok button.
34
FastStor 1 Installation and User Guide
