LED Indicators
The two LED indicators are green and amber. They indicate the FastStor 1 activity
as follows:
•
Green LED on: The FastStor 1 is either running or ready for operation.
•
Green LED blinking: Short blinks followed by long intervals indicate that the
loader is in low power standby mode.
•
Amber LED on: Fault LED; the FastStor 1 has encountered an electrical or
mechanical failure.
•
Both LED’s off: The FastStor 1 is offline. This is the case while the loader is
initializing after power-on, and when a magazine is removed.
Standby Switch
A switch on the front panel provides a Loader Standby. If the switch is pushed
when the loader is active, the loader completes the current operation and then
goes offline and enters standby mode. See Standby Functionality for more details.
Magazine Front Bezel
The front bezel of the magazines is visible from the front. All magazine handling is
described in detail in Magazine Handling.
Rear Panel
The figure below shows the rear panel of the FastStor 1.
Power
switch
Fuse Power
cord
connection
Fan Back
panel
cover plate
Fan SCSI
connectors
Ethernet
port
Figure 2.5 Rear panel of the FastStor 1
Two Integrated Cooling Fans
The rear panel contains two forced-air cooling fans, which draw air inward through
the front and expel it out in the back. The fans start whenever the drive is operating
or when the internal temperature in the FastStor 1 gets too high.
6
FastStor 1 Installation and User Guide
