Diagnostics
Gate Movement Errors
CubiScan 125 Service Manual
9
If the CubiScan 125 reports
Badpk
, make sure that nothing is blocking the sensor. This
message may also mean that the CubiScan 125 is receiving faulty or garbled information from
the sensor.
If the CubiScan 125 reports
UStbl
, make sure that nothing is blocking the sensor.
If no error messages are reported, continue on to the next step.
6. Are all cables securely connected to the ultrasound sensors and the controller?
7. Are any covers blocking the ultrasound waves? You may need to adjust the position of the
sensors if they are being blocked.
8. Are any of the ultrasound sensors or cables visibly damaged? If you require replacement
parts, please contact Quantronix Technical Assistance at +1 801-451-7000.
Gate Movement Errors
This section describes the various gate movement errors that can occur with the CubiScan 125.
Refer to the following sections for more information.
Gate Cursor Not Moving
Complete the following steps if the green gate cursor does not follow the gate’s movements.
1. Check the encoder cable and make sure it is securely attached at both ends of the cable. If
doing this does not correct the problem, continue on to the next step.
2. Check the encoder and see if it is visibly damaged. Contact Quantronix at +1 801-451-7000 if
you need a replacement part.
3. Go to
Menu > Diagnostics > Encdr
. The encoder value should read
0000
when the gate is in the
home position. Move the gate all the way to the left and back into the home position. If the
encoder value does not change, please contact Quantronix Technical Assistance at +1 801-
451-7000.
Gate Cursor Out of Box
Complete the following steps if the green gate cursor is out of the box.
1. When the CubiScan 125 reboots, make sure that it declares “CubiScan 125 Ready” after all the
files have been initialized. If it declares “CubiScan 25 Ready,” the wrong CubiScan may be
selected in the firmware.
2. If, after completing the above step, the gate cursor is still not functioning, please contact
Quantronix Technical Assistance at +1 801-451-7000.
