43
DS-1200 G4i Operator Manual Issue 4 - Nov 2020
3
Enter an envelope name.
4
Select envelope size. If you change default dimensions, size will change to
Custom
.
NOTE:
Measure envelope carefully before changing sizes.
5
Enter the paper weight and envelope thickness and weight will automatically
calculate, or press
Computed
and enter actual figures.
6
If using a reading label on the envelope, enter the definition name.
7
The shield setting controls the amount of shielding over the separator roller
and should not normally require adjustment. However, if stream-feeding or erratic
double feeds occur, try moving the shield back (ie. reducing the percentage). If
envelopes are not properly picking up, move it forward.
8
If an alternative finger set is required to be used, enter its number. The
operator will then be prompted to change the finger set when the job is run.
9
Wetting rate number shown is the amount of wetting applied to the envelope
flap. Default is 3, maximum is 8.
10
Press
Save
when done.
The envelope is now fully defined and is available for use.
Envelopes can also be created from the Menu screen if you
have appropriate access rights.
