Qlogic iSR6142, User Manual

Page: 28 / 172

3 – Managing the Router
iSR6142 Router
3-4 SN0054660-00 A
S
„ IPv4 Management Info – Select this check box to use IPv4 (Internet
Protocol version 4, 32-bit addressing), then use the radio buttons to identify
whether to use a dynamic or static IP address.
„ IP Address – Displays the management port’s subnet mask.
„ If you selected the Obtain an IP address automatically (DHCP)
radio button, the system obtains the IP address automatically
through DHCP.
„ If you selected the Use the following IP address radio button,
you can configure the IP address.
„ Subnet Mask – Displays the management port’s subnet mask.
„ If you select the Obtain an IP address automatically (DHCP) ,
the system obtains the subnet mask automatically through
DHCP.
„ If you selected the Use the following IP address radio button,
you can configure the subnet mask.
„ Gateway – Displays the IP address of the server acting as a gateway
to your Internet connection.
„ If you select the Obtain an IP address automatically (DHCP) ,
the system obtains the gateway address automatically through
DHCP.
„ If you selected the Use the following IP address radio button,
you can specify the gateway address.
„ IPv6 Management Info – Select this check box to use IPv6 (Internet
Protocol version 6, 128-bit addressing), then use the radio buttons to identify
whether to use a dynamic or static IP address.
„ IPv6 Management Info – Select this check box if you want to use
IPv6, then use the radio buttons to identify whether to use a dynamic
or static IP address.
„ IPv6 Address1 – The first user-assigned IPv6 address to which the
port responds. A value of :: indicates that an IPv6 address has not
been assigned. Although you may modify the IP address in this
window, you will typically set it using the Configuration Wizard.
„ IPv6 Address2 – The second user-assigned IPv6 address to which
the port responds. A value of :: indicates that an IPv6 address has not
been assigned. Although you may modify the IP address in this
window, you will typically set it using the Configuration Wizard.