Qlogic iSR6142, User Manual

Page: 104 / 172

4 – Using the Wizards
FCIP Route Add Wizard
4-46 SN0054660-00 A
S
The FC and GigE Port Selection dialog box prompts you to select an
FC-GigE port pair, as shown in Figure 4-55 .
Figure 4-55 FCIP Route Add Wizard—Port Selection Dialog Box
2. Select the FC-GigE Port pair. The corresponding parameter options become
available.
3. If desired, configure the following port route/parameters:
„ FCIP Interfaces FC & GE – Provides a drop-down box you can use to
enable or disable the FCIP route. Disabling the route places the FC
and GE ports in a down state. It still retains all route configuration
parameters.
„ GigE Port Programmed Link Rate – Provides a drop-down box you
can use select one of four options for the GigE link rate: Auto , 10 , 100 ,
or 1000 . The default link rate is Auto .
„ Link Rate Mode – Provides a drop-down box you can use select one
of three options for the link rate mode: Auto , Half Duplex , or Full
Duplex . This dialog box is available only when the GigE link rate is set
to something other than Auto .
„ GigE Port Flow Control – Provides a drop-down box you can use to
enable or disable GigE port flow control. The default is enabled. This
dialog box is available only when the GigE link rate is set to something
other than
Auto .
4. After selecting a port pair and setting GE port parameters, click Next to
continue or click Cancel to quit the wizard.