Qlogic iSR6142, User Manual

Page: 152 / 172

B – Simple Network Management Protocol (SNMP)
Introduction
B-2 SN0054660-00 A
S
SNMP Trap Configuration
SNMP trap configuration supports setting up to eight trap destinations. Choose
from Traps 1–Trap 8 to configure each trap.
Table B-2 describes the parameters
for configuring a SNMP trap.
System contact Specifies the name of the person to be contacted to respond to
trap events. The name can be up to 64 characters
excluding
the number sign (#), semicolon (;), and comma (,). The default
is undefined.
Authentication traps Enables or disables authentication trap generation in response
to authentication failures. The default is disabled.
Table B-2. SNMP Trap Configuration Parameters
Parameter Description
Trap n enabled Enables or disables trap n . If disabled, the trap is not configured.
Trap address
*
Specifies the IP address to which the SNMP traps are sent. A max-
imum of eight trap addresses are supported. The default address
for traps is 0.0.0.0.
Trap port
*
The port number on which the trap is sent. The default is 162.
Trap version Specifies the SNMP version (1 or 2) with which to format traps.
*
Trap address (other than 0.0.0.) and trap port combinations must be unique. For example, if trap 1 and trap 2
have the same address, then they must have different port values. Similarly, if trap 1 and trap 2 have the same
port value, they must have different addresses.
Table B-1. SNMP Properties (Continued)
Parameter Description