Pulse Secure MAG2600, Hardware Manual

Page: 76 / 86

MAG Series Pulse Secure Gateways Hardware Guide
© 2016 Pulse Secure, LLC., All rights reserved. 76
Packing for Shipment
Tools and Parts
To remove components from the Pulse Secure Gateway or to remove the Pulse Secure Gateway from a rack,
you need the following tools and parts:
• Flat-blade (–) screwdriver
• 7/16-in. (11-mm) nut driver
• Blank panels to cover empty slots
• Electrostatic bag or antistatic mat, for each component
• Electrostatic discharge (ESD) grounding wrist strap
• Mechanical lift, if available
• Phillips (+) screwdrivers, numbers 1 and 2
• Rubber safety cap for fiber-optic interfaces or cable
• Wire cutters
Packing the Pulse Secure Gateway
To pack the Pulse Secure Gateway for shipment:
1. Retrieve the shipping crate and packing materials in which the Pulse Secure Gateway was originally
shipped. If you do not have these materials, contact your Pulse Secure representative about approved
packaging materials.
2. Shut down the Pulse Secure Gateway software.
3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one
of the ESD points on the chassis.
4. Shut down power to the Pulse Secure Gateway.
5. Disconnect power from the Pulse Secure Gateway.
6. Remove the cables that connect to all external devices.
7. Remove all field replaceable units (FRUs) from the Pulse Secure Gateway.
8. Remove the Pulse Secure Gateway chassis from the rack, using one of the following methods:
• If you are using a mechanical lift, place the lift platform under the chassis, unscrew and remove the
mounting screws from the rack, and move the chassis to the shipping crate.