Pulse Secure MAG2600, Hardware Manual

Page: 36 / 86

© 2016 Pulse Secure, LLC., All rights reserved. 36
MAG Series Pulse Secure Gateways Hardware Guide
3. Install the MAG-SM361 in the open slot.
4. Remove the blank fan tray covers on the back panel of the Pulse Secure Gateway directly behind the
MAG-SM361 and install the fan trays in the slots.
NOTE: It is important that you install the fan trays directly behind the MAG-SM361 to ensure proper
airflow across the service module.
5. Remove the blank hard drive covers on the back panel of the Pulse Secure Gateway directly behind the
MAG-SM361 and install both hard drives.
Hard drives for the MAG-SM361 are slot dependent. The boot drive (labeled “bottom slot drive”) must
be placed in the lower slot. The second drive (labeled “top slot drive”) must be placed in the upper slot.
NOTE: Hard drives must be installed directly behind their corresponding service module. They are
labeled with the same serial number as their paired service module to ensure they are installed in the
correct slot. They are also labeled with their slot location (top or bottom). Do not interchange them.
If you do not install the hard drives in the correct slots, they will not be recognized by the MAG-SM361
and you will receive a drive error when powering up the Pulse Secure Gateway.
If the hard drives or MAG-SM361 service module fails, the entire kit must be replaced. Since the hard
drives are paired to the specific hardware ID, a failure of the hard drives or the service module requires
a full replacement rather than individual component troubleshooting.
NOTE: If you later move the MAG-SM361 service module to a different slot, you must move its fan tray
and hard drives to the new location as well.
Installing an AC Power Supply in the MAG6610 and MAG6611
Before you install an AC power supply in the Pulse Secure Gateway, make sure that you understand how to
prevent ESD damage.
NOTE: Each power supply must be connected to a dedicated power source outlet.
The power supply in the Pulse Secure Gateway MAG6611 is a hot-removable and hot-insertable field-
replaceable unit (FRU). If you have two power supplies already installed, you can remove and replace one of
the power supplies without powering off the Pulse Secure Gateway.
The AC power supply is neither a hot-removable nor a hot-insertable FRU on the MAG6610. You must power
off the MAG6610 before replacing the AC power supply. The MAG6610 is shipped with the power supply pre-
installed. Follow these instructions only if you need to replace the power supply on the MAG6610.
To install a power supply in the Pulse Secure Gateway:
1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to the
ESD point on the chassis.
2. If the power supply slot has a cover panel on it, pull the handle of the cover panel outward and remove
the panel. Save the cover panel for later use.