Pulse Secure MAG2600, Hardware Manual

Page: 34 / 86

© 2016 Pulse Secure, LLC., All rights reserved. 34
MAG Series Pulse Secure Gateways Hardware Guide
3. Place the service module serial number sticker on the back panel of the Pulse Secure Gateway chassis,
directly behind the service module slot where you have installed the MAG-SM360.
Service modules are paired with fan trays and hard drives. Hard drives have a serial number label that
matches the associated service module. Placing the service module serial number sticker on the back
panel of the Pulse Secure Gateway chassis helps you ensure that you have the correct hard drive paired
with the service module.
4. Remove the blank fan tray covers on the back panel of the Pulse Secure Gateway directly behind the
MAG-SM360 and install both fan trays in the slots.
5. NOTE: It is important that you install the fan trays directly behind the MAG-SM360 to ensure proper
airflow across the service module.
6. Remove the blank hard drive covers on the back panel of the Pulse Secure Gateway directly behind the
MAG-SM360 and install both hard drives.
Vertical slot order does not matter for the MAG-SM360 RAID1 drives. As long as the drive signatures
match the blade’s RAID 1 configuration, it accepts both drives regardless of the slots in which they are
installed, assuming they are paired with the appropriate service module.
NOTE: Hard drives must be installed directly behind their corresponding service module. They are
labeled with the same serial number as their paired service module to help ensure they are installed in
the correct slots. Do not interchange them with other service modules.
If you do not install the hard drive in a slot associated with the appropriate service module, it is not
recognized by the MAG-SM360, and you receive a drive error when powering up the Pulse Secure
Gateway.
If you later move the MAG-SM360 service module to a different slot, you must move its fan tray and
hard drives to the new location as well.
Installing the MAG-SM161 Kit
The MAG-SM161 kit includes:
• One MAG-SM161 service module
• Two fan trays
• One hard drive
The cover plate on the left can be removed to accommodate the MAG-CM060 Chassis Management Card.
NOTE: RAID is not supported with the MAG-SM161.
The basic steps for installing the MAG-SM161 kit are:
1. Remove the face plate on the Pulse Secure Gateway corresponding to the slot where you want to install
the MAG-SM161.
2. Service modules include an additional serial number. Remove this serial number and place it on the
back panel of the Pulse Secure Gateway, directly behind the slot where you are installing the MAG-
SM161.