Pulse Secure MAG2600, Hardware Manual

Page: 71 / 86

MAG Series Pulse Secure Gateways Hardware Guide
© 2016 Pulse Secure, LLC., All rights reserved. 71
To remove the MAG-SM160, MAG-SM360, MAG-SM161 and MAG-SM361 service module:
1. Pull the ejector lever, located under the service module, outward until it is fully open.
2. Gently pull on the service module front panel to slide it halfway out of the chassis.
3. Using both hands, hold the front edge of the service module, and slide it completely out of the chassis.
4. Place the service module in an antistatic bag or on an antistatic mat on a flat, stable surface.
NOTE: Faceplates are required for proper cooling and airflow. If you do not intend to replace the service
module, cover the opening with a blank faceplate.
Maintaining Hardware Components
This table describes the common tasks for maintaining the hardware components of the Pulse Secure
Gateway.
Maintenance Procedure Procedure
Routine maintenance procedures To maintain optimum performance of the Pulse Secure
Gateway, you should regularly perform the following preventive
maintenance procedures:
•Inspect the installation site for moisture, loose wires or cables,
and excessive dust.
•Make sure that the airflow is unobstructed around the device
and into the air intake vents.
•Check the Status LED on the front panel of the MAG2600
or the service module on all other Pulse Secure Gateway
models.
Maintaining the cooling system
The Pulse Secure Gateway cooling system works to maintain
an optimal temperature for the device. If the fan controller
fails, the device temperature will exceed the maximum working
temperature, and the device will fail. Make sure that you
maintain the recommended clearances behind the device to
enable the cooling system to function optimally.
Maintaining the power supply To maintain the power supply on the Pulse Secure Gateway:
•Make sure that the power and grounding cables are
arranged so that they do not obstruct access to other device
components.
•Periodically inspect the site to ensure that the grounding and
power cables connected to the device are securely in place
and that there is no moisture accumulating near the device.
CAUTION: We recommend using a surge protector for the power connection.