Pulse Secure MAG2600, Hardware Manual

Page: 58 / 86

MAG Series Pulse Secure Gateways Hardware Guide
© 2016 Pulse Secure, LLC., All rights reserved. 58
8. Secure the grounding cable lug to the grounding points, first with the washers, and then with the
screws.
9. Dress the grounding cable, and verify that it does not touch or block access to device components,
and that it does not drape where people could trip on it.
Connecting Power to an AC-Powered Pulse Secure
Gateway
You connect AC power to the device by attaching power cords from the AC power sources to the AC appliance
inlets located on the power supplies of the Pulse Secure Gateway.
The power cords are provided with the Pulse Secure Gateway.
To connect the AC power cords to the device for each power supply:
1. Locate or obtain the power cords you will use with the Pulse Secure Gateway. The power cords must
have a plug appropriate for your geographical location.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one
of the ESD points on the chassis.
3. Insert the appliance coupler end of the power cord into the inlet on the power supply on the back
panel of the Pulse Secure Gateway chassis.
4. Insert the power cord plug into an external AC power source receptacle.
NOTE: Each power supply must be connected to a dedicated AC power feed and a dedicated external
circuit breaker. We recommend that you use a 15 A (250 VAC) minimum, or as permitted by local code.
5. Dress the power cord appropriately. Verify that the power cord does not block the air exhaust or access
to device components, and that it does not drape where people could trip on it
6. Repeat Step 1 through Step 6 for the remaining power supplies.