Using Web Interface to Manage the Access Point
AP-8000 User Guide
92
Figure 6-48 Management Access Control Page
2. Select the
Access Table Status
checkbox. This will enable the Management Access Control.
NOTE:
The
Add
button is displayed, only when the Access Table Status is enabled.
3. Click
Add
to make a new entry
.
The
Management Access Table Add Row
page appears.
Figure 6-49 Management Access Control - Add Row Page
4. Enter the
IP Address
of the device.
5. Select the
Entry Status
.
6. Click
Add
.
7. Click
REBOOT
to apply the changes to the AP device.
Reset to Factory
Resetting the AP to its factory defaults will remove the configuration file and reboots the AP device automatically.
To Reset the Factory defaults,
1. Navigate to
Management
>
Reset To Factory
. The following page appears.
Figure 6-50 Reset to Factory
2. Click
Ok
to reset factory settings else click
Cancel
.