Using Web Interface to Manage the Access Point
AP-8000 User Guide
78
2. Configure the following parameters.
•
VLAN Status:
Select VLAN Status. This will enable the VLAN feature for the device.
NOTE:
To Disable VLAN, uncheck the Status box and click COMMIT button to update the changes.Once you
Commit, Reboot the AP device.
•
Management VLAN ID:
Enter value for Management VLAN ID. Its value ranges from 1 to 4094. (A Value of -1
disables the VLAN Tagging).
CAUTION:
If a non-zero management VLAN ID is configured then management access to the AP is restricted to
wired or wireless hosts that are members of the same VLAN. Ensure your management platform or
host is a member of the same VLAN before attempting to manage the AP.
3. Click
OK
.
4. Click
COMMIT.
5. Click
REBOOT.
NOTES:
•
You need to click
Commit
button to update/reflect the changes. If you do not click Commit, then the device will not
be able to tag the incoming wireless packets. Once you commit,
Reboot
the AP device.
•
When VLAN is enabled ensure that all devices in the network share the same VLAN ID as this will ensure that all
the Access Points are managed easily.
•
In the case of Radius server authentication or EAP authentication, if the radius server is present on any VLAN,
then the Radius server should be the member of management VLAN ID of an AP.
Filtering
The Access Point’s Packet Filtering features help to control the amount of traffic exchanged between the wired and
wireless networks. The various Filtering modes supported by AP are described in the following sections:
•
•
•
•
•
Filtering
To configure the status of
Global Filter Flag
and
Intra BSS Filtering
,
1. Navigate to
Configuration > Filtering
. The
Filtering
page appears.
Figure 6-29 Filtering Page