iSCSI GbE to SAS/SATA II RAID Subsystem
User Manual
71
3.8.2 Upgrade
“Upgrade”
is used to upgrade firmware. Please prepare new firmware file named
“xxxx.bin”
in local hard drive, then click “
” to select the file. Click
“
”, it will pop up a message “Upgrade system now? If you want
to downgrade to the previous FW later (not recommend), please export your system
configuration in advance”, click
“Cancel”
to export system configuration in advance,
then click
“OK”
to start to upgrade firmware.
When upgrading, there is a progress bar running. After finished upgrading, the system
must reboot manually to make the new firmware took effect.
NOTE: Please contact your vendor for the latest firmware.
3.8.3 Reset to Factory Default
“Reset to factory default”
allows user to reset controller to factory default setting.
Reset to default value, the password is:
00000000
, and IP address to default DHCP.
Default IP address:
192.168.10.50
(DHCP)
Default subnet mask:
255.255.255.0
Default gateway:
192.168.10.254
