Promag TR510E, Manual

Page: 9 / 62

TR510E User’s Manual
9
ASCII characters- ‘7’ and ‘D’).
STX A 1 X Y Z 7 D CR
02H 41H 31H 58H 59H 5AH 37H 44H 0DH
Packet portion the checksum is calculated on Checksum
Table below lists all possible error codes:
04 Illegal (invalid) command (command code or data is wrong)
06 Record number is out of range (requested record doesn’t exist)
07 Command failed (hardware problem or invalid internal data)
08 Log (data) memory is full (this message reply in Extended mode)
09 Command is denied by terminal (cannot process this command at
the moment)
Summarized below are all supported commands. Command characters are
found in the “CC” column, their corresponding ASCII codes- in “Hex”. “CS” lists
commands that require the checksum in the command packet (“C”) or reply
packet (“R”). “Error code” column lists errors that may result from each
command execution:
C.
C.
Hex Description CS Errors
C R 4 6 7 9
‘D’ 44H Select designated terminal Note 1
‘I’ 49H Set new machine number + +
‘Y’ 59H Get machine number +
‘S 53H Set date/time + +
‘T’ 54H Get date/time +
‘V’ 56H Get firmware version
‘R’ 52H Initialize the terminal +
‘C’ 43H Set group-1 registers (see group-1
table)
+ +
‘B’ 42H Get group-1 registers (see group-1
table)
+ + +
‘P’ 50H Set group-2 registers (see group-2
table)
+ +
‘Q’ 51H Get group-2 registers (see group-2
+ + +