Promag TR510E, Manual, Page: 5 / 62

TR510E User’s Manual
5
address it with the universal number.
For multi-terminal Ethernet communications, you’ll need to assign a unique
(and non-zero!) machine number to each Terminal on the network.
The TR510E offers a fast and convenient way of assigning machine
numbers in the range from 0 to 10. To assign a new machine number:
Assigning machine numbers
•
Power the Terminal down (unplug the power cord)
•
Press and hold the OUT button
•
Power the Terminal up while continuing to hold down the OUT button
•
After 2-3 seconds, the Terminal will beep and display its current
machine number, for example:
•
While still keeping the OUT button pressed, push the IN button
(several times if necessary) to change the machine number to the
desired value
•
When the desired machine number is displayed, release the OUT
button- the Terminal will resume normal operation
This method allows you to set the numbers in the 0-10 range only (which
would actually cover most of the actual installation requirements). If you need to
set the machine number to, say, 25, then you will have to follow this procedure:
•
Connect the TR510E to the HUB using the Ethernet cable
•
Launch the TR510 Control Center software and select the Terminal
#0 (i.e. use the universal machine number to address the Terminal)
•
Use the “Set M#” button to set the new machine number for this
Terminal
•
Use the “Get M#” button to get the new machine number for check if
machine number has changed.
Note: machine number is displayed briefly at the Terminal power-up (even if
you don’t push the OUT button).
The TR510E features a built-in bell relay. The relay is capable of controlling
a low-power external bell. There are two modes for bell schedule, one is
Everyday mode another is Week mode. Only one table in Everyday mode, a
Bell relay