52
6
Digital Effects | Master Control
6.4
System Menu
StudioLive™ 16.0.2 USB
Owner’s Manual
6.4.2
Aux Send Position
Press the Page Down button to access the Aux Pre Position page. By default, all four
aux buses are set to Pre 1. This places the send of all 16 channels to the aux bus
before the fader, limiter, EQ, and compressor and after the phase-reverse switch,
high-pass filter, and noise gate. The two internal effects buses are set to Post, which
sends each of the channels after all Fat Channel dynamics and EQ and the fader.
From this menu, you can choose between three send positions for each aux mix:
Pre 1: Sends each channel to the aux bus after the
polarity invert, high-pass filter, and gate.
Pre 2: Sends each channel to the aux bus after all Fat Channel parameters (polarity
invert, high-pass filter, gate, compressor, EQ, and limiter) but before the fader.
Post: Sends each channel to the aux bus after all Fat Channel parameters (polarity
invert, high-pass filter, gate, compressor, EQ, and limiter) and after the fader.
Power User Tip:
Use the Pre 2 position for headphone and in-ear mixes to give your
performers a polished “studio” sound. This setting should be avoided for floor wedges, as
compression can cause feedback problems!
If you have two aux buses stereo-linked, you only need to set the Pre
position on the Link Master. Remember, the Link Master is the aux that
was selected when the link was created. To determine which aux is the
Link Master, simply select either of the aux buses in the pair. The Link
Master‘s ID will be shown in the Select Channel LED readout.
6.4.3
MIDI Control Mode
The StudioLive 16.0.2 USB can be remotely controlled with a DAW, a MIDI footswitch,
a MIDI keyboard, and an assortment of other MIDI control devices. Pages 3 and
4 of the System menu allow you turn MIDI Control Mode on as well as select on
which MIDI channels the StudioLive will be controlled, as well as which MIDI
Control Change messages will be used.
See Section 6.5 for more information
Summary of Contents for StudioLive 16.0.2 USB
Page 4: ......
