Tacker
operation 4C-WZ38BNH / 4C-WZ38BNH400
31
ATTENTION
Observe the Hazard Warnings in the “Safety” section, starting
on page
Fehler! Textmarke nicht definiert.
.
Position a carton at least 16 mm thick in the opening between the
die and discharge opening.
Trigger the tacker (see
section “
Fehler! Verweisquelle konnte
nicht gefunden werden.
“ starting on page
Fehler! Textmarke
nicht definiert.
).
Check the following properties:
-
Triggering occurs only when the trigger safety is pressed.
-
One fastener must be driven into the carton material for each
pull of the trigger.
-
Exhaust air must not blow towards the face.
To obtain the desired bending profile if needed, change the
operating pressure, the bottom retaining clip (see page
Fehler!
Textmarke nicht definiert.
), or the carton thickness setting (see
page 35).
Repeat these steps as needed.
The tacker is now ready for operation.
Contact triggering
The device is set for contact triggering. For repeated triggering, you
do not need to press the trigger each time. Each trigger action drives
one staple into the material.
Summary of Contents for 1A-AZ16BNH
Page 28: ...Eintreibger t bedienen 4C WZ38BNH 4C WZ38BNH400 28...
Page 47: ...Nach dem Betrieb 47 Schlie en Sie das Magazin siehe Seite 29...
Page 117: ...After operation 47 Close the magazine see page 28...
Page 137: ...Technical data 67 Noise characteristics per DIN 12549 1999 LWA 1s 95 3 dB LpA 1s 82 3 dB...
