Tacker
operation 4C-WZ38BNH / 4C-WZ38BNH400
36
WARNING
Accidentally triggering when selecting the
carton thickness can cause severe or fatal
injury.
Do not point the tacker at yourself, people
or animals.
To select the carton thickness, proceed as follows:
Carton thicknesses are marked on the clip on the unit (10).
Open the clamp lever (8) by rotating the lever counterclockwise.
Remove the retaining ring (2) on the locking pin (7).
Pull out the locking pin (7).
Set the two clips (3) so that the holes (9) in the clip (3) align with
the hole in the spacer (4) below the desired carton thickness.
Insert the locking pin (7) through the aligned holes (9) and install
the retaining ring (2) on the locking pin (7).
Close the clamp lever (8) by rotating the lever clockwise.
The desired carton thickness is now set.
Carton thickness is set to 30 mm when the holes on the left
are aligned. The center holes are for 20 mm and the holes on
the right are aligned for carton thickness of 16 mm.
Summary of Contents for 1A-AZ16BNH
Page 28: ...Eintreibger t bedienen 4C WZ38BNH 4C WZ38BNH400 28...
Page 47: ...Nach dem Betrieb 47 Schlie en Sie das Magazin siehe Seite 29...
Page 117: ...After operation 47 Close the magazine see page 28...
Page 137: ...Technical data 67 Noise characteristics per DIN 12549 1999 LWA 1s 95 3 dB LpA 1s 82 3 dB...
