PowerBoss, Inc.
Copyright 2008
Armadillo
®
SW/10XV
PB # 4100034 / Rev. 01A08
Page 37
Operation, Maintenance and Troubleshooting
S E R V I C E I N S T R U C T I O N S ( C O N T I N U E D )
H Y D R A U L I C S S Y S T E M ( C O N T I N U E D )
3.
Locate the forward / reverse adjustment bracket mounted beneath the pump on the
pump
mounting
plate.
4.
Slightly loosen the bolt on the center of the bracket.
5.
Loosen the locking nut on each of the adjusting bolts on the side of the bracket
closest to the pump mounting plate.
6.
From the operator’s seat, start the engine and run at half throttle.
7.
Turn the adjusting bolts while watching the rear wheel. Continue to adjust until the
rear wheel does not turn in either direction.
8.
Fully open the throttle. Push the directional control pedal forward and backward to
be sure the pump stays in neutral. Check the wheel again and adjust as needed until
the
wheel
remains
motionless.
9.
Retighten all the locking nuts and bolts.
10.
Turn the engine off and lower the machine to the floor.
