PowerBoss, Inc.
Copyright 2008
Armadillo
®
SW/10XV
PB # 4100034 / Rev. 01A08
Page 20
Operation, Maintenance and Troubleshooting
SLOWING AND
STOPPING
OPERATING ON
GRADES
SWEEPING
EMPTYING THE
HOPPER
High Dump
Models
1. Allow the directional control pedal to move into neutral. The
machine will slow and coast to a stop.
1. Always travel slowly.
2. Exercise extreme caution when traveling across or turning on
grades.
1. Lower the Brooms
٭
When sweeping extremely uneven floors, position
the main broom handle at FLOAT on the handle slot.
٭
Lower the side broom by positioning the side broom
handle at LOWER in the handle slot.
٭
Lower the main broom by positioning the main
broom handle to LOWER on the handle slot.
2. Activate the broom motors.
٭
Activate both main and side broom motors by push
ing the broom and brush control lever to the ON
position.
٭
Activate the main broom motor by pulling the broom
and brush control lever to the SIDE BROOM OFF
position.
Broom control lever must be in the center OFF position.
3. Drive the machine over the area to be swept.
1. Drive the machine to the dumping area.
2. Use the directional control pedal to position the machine so
that the space between the machine and the container or
dumpster is adequate to raise the hopper.
3. Reduce the engine speed.
4. Pull back Lever 1 to the RAISE position and hold until the
bottom of the hopper is high enough to clear the top of the
container.
NOTE
