PowerBoss, Inc.
Copyright 2008
Armadillo
®
SW/10XV
PB # 4100034 / Rev. 01A08
Page 21
Operation, Maintenance and Troubleshooting
USING THE
ROTARY TRASH
RELOCATOR
(RTR™)
Never place your hands or other body parts near the lift arms
when the hopper is operating.
5. Use the directional control pedal to slowly and carefully move
the machine forward until the hopper is properly positioned to
dump the debris into the container.
It is unsafe to travel an extended distance with the hopper
raised. Travel only the distance necessary to position the
hopper.
6. Shake the filters for 20-30 seconds. Pull back Lever 2 to the
DUMP position to rotate the hopper forward and empty the
debris.
7. After the hopper empties, push Lever 2 forward to the
RETURN position until the hopper rotates and stops.
8. Slowly back the machine away fro the dumpster
approximately 5 feet.
9. Push Lever 1 forward to the LOWER position until the
hopper stops.
1. Use the directional control pedal to stop the machine on a
level surface.
2. Move the throttle to the IDLE position.
As you complete Steps three and four, observe the two red
lights labeled 1 and 2 in the upper left corner of the control
pane.
•
Light 1 illuminates when the hopper reaches the minimum
height required to use the RTR™ feature.
•
Light 2 illuminates when the hopper reaches the rotation stop
point.
3. Pull back Lever 1 to the RAISE position and hold until Light
1 illuminates, then release.
Make sure no one is in the area under or around the hopper.
WARNING
WARNING
WARNING
NOTE
