PowerBoss, Inc.
Copyright 2008
Armadillo
®
SW/10XV
PB # 4100034 / Rev. 01A08
Page 36
Operation, Maintenance and Troubleshooting
S E R V I C E I N S T R U C T I O N S ( C O N T I N U E D )
H Y D R A U L I C S S Y S T E M ( C O N T I N U E D )
Ten (10) gallons (US) of fluid are required.
6.
Install the filler cap assembly.
7.
Check the drain plug for leakage.
CHANGING THE HYDRAULIC FLUID FILTER
1.
Turn off the engine and engage the parking brake.
2.
Unscrew the oil filter cartridge from the mount and discard in an approved manner.
3.
Apply a thin coating of fluid to the seal of a new filter element.
4.
Thread onto the mount and hand tighten.
5.
Tighten an additional one-half turn beyond hand tight.
Do not over tighten.
5.
Start the machine, shut it off, then check for leakage.
ADJUSTING THE DIRECTIONAL CONTROL RETURN SPRING
You may encounter “creeping” problems from time to time. Creeping means the machine moves
backward or forward when the forward/reverse pedal is in neutral. A grinding noise when the
engine is shut down is a so an indicator that the directional control return spring needs adjusting. If
this occurs, perform the procedure which follows:
1.
Turn off the engine, engage the parking brake and chock both wheels.
2.
Jack the rear of the machine so that the rear tire just clears the floor. Use two jack
stands to support the machine.
DO NOT USE A JACK ALONE TO HOLD THE
MACHINE!!!
NOTE
WARNING
NOTE
