power automation PA 8000 LW Series, Installation Instructions Manual, Page: 15 / 132

n When selecting personnel, ensure that the personnel can work
with the control unit in terms of technical and content aspects.
2.3 Intended use
The control unit is exclusively intended and built for the use described
in this installation manual.
The control unit is to be used exclusively to control CNC machines of a
supported number of axes which are in accordance with the types
cleared by Power Automation. Prerequisite for the intended use of the
control unit is proper configuration as described in the installation man-
uals provided by Power Automation.
Beware of unintended use!
–
Operate the control unit as intended only.
– Observe all instructions in this installation manual.
– Observe the permissible ambient conditions and electromag-
netic compatibility mentioned in the technical data.
Any use exceeding the scope of intended use and/or different
application of the control unit can result in hazardous situations.
Claims of any kind for damage resulting from unintended use are void.
The operator is solely responsible for all damage resulting from
unintended use.
2.4 Unintended use
Beware of unintended use!
–
In particular, avoid using the control unit for the following pur-
poses as these are regarded as not intended:
–
Operation using software not approved by
Power Automation.
– Operation connected to machines/drives not deemed com-
patible by Power Automation.
– Operation using wrong number of axes
– Wrong or missing execution of the maintenance intervals
– Operation by not instructed personnel
Intended Use
Dangers
L
WARNING
Unintended Use
L WARNING
PA 8000 LW CNC control unit
Safety
25.09.2015 | 15