- 58 -
0600_GB-Power-Control_8537
GB
POWEr COnTrOL - OPErATiOn
- After 10 registered seed drive rotations
- Indicator in display “Finish rotations” and “Empty
troughs”
- Empty the troughs
- Re-install in calibrating position
Confirm process with OK
Using arrow keys select “Calibration areas”
(Abdrehfläche) and confirm with OK.
- Possible areas:
1/10ha, 1/20ha, 1/40ha, 1/100ha
- The indicated crank handle rotations must be made
using the crank handle.
- The control keeps count and displays the remaining
crank handle rotations.
- An acoustic signal is heard with the last 5 crank
handle rotations to draw attention to the fact that
the calibrating process will end soon.
- When the value reaches 0 the STOP indicator
appears in the display and continuous acoustic
signal is heard.
- Calibration must now end.
- The actual crank handle rotations are shown.
Press OK key (F)
The control calculates a theoretical set quantity “Soll”
from the given values
The actual quantity “Ist” is the real yielded seed
quantity.
- Now weigh the actual quantity in the troughs
- Input this actual quantity using the “+/- keys”
- Confirm input with OK
The programme calculates the new gearing position
- If a greater gearing position is calculated, the request
“Please turn handle” appears because the drive
must be adjusted upward.
- Turn the crank handle until the new gearing position
is started.
- If a smaller gearing position is calculated, this will
be started immediately.
- Turning the crank handle does not apply.
If the gearing position is started, the inquiry appears
asking if the calibration trial (Abdrehprobe) should be
repeated.
- With “OK” (key F) the calibration trial (Abdrehprobe)
can be repeated
- The programme goes back to “Select calibration
areas” (Abdrehfläche auswählen)
- Calibration is ended with ESC
- The programme goes back to “(Select calibration
trial/calibration aid” (Abdrehprobe/Abdrehhilfe
auswählen)
Note!
The calibration
menu
(Abdrehmenü) can
be exited in the
following way:
Use keys
,
,
,
,
or
