Pitney Bowes DI500, Operator'S Manual

Page: 44 / 128

3 • Operator Functions
3-14 SV40221 Rev. C
Setting the Sheet Feeders
Sheet Feeders A to D feed sheets that require folding by the
machine.
The Mail Piece Icon Tree for the job being run will show which
feeders need to be loaded and the sheet orientation. If you need help
understanding the sheet icons, refer to page 1-12 of this guide.
The Prime Sheet or Set (normally containing the address) will be fed
from the top feeder for C or Double Fold jobs and from the bottom
feeder for single or Z fold jobs. This will be indicated by the Mail
Piece Icon Tree.
Sheet Feeders can feed single Sheets or Pre-Collated Sets,
depending on job setup. The Mail Piece Icon Tree will tell you the
quantity of sheets that the machine is programmed to run from
each feeder if Pre-Collated sets are programmed. If you need help
understanding the terms Sheet or Pre-Collated Set, refer to page
1-14 of this guide.
1. Adjust the side guides to
the width of the material
being fed using the Side
Guide Adjustment Knob,
then back-off 1/4 of a turn.
This will set the correct
clearance between the
guides and sheets.
2. Take the relevant Stack of
sheets and fan it to ensure
individual sheets are not
stuck together.