Pitney Bowes DI500, Operator'S Manual

Page: 40 / 128

3 • Operator Functions
3-10 SV40221 Rev. C
SwiftStart™ Operation
Load material as previously described and select SwiftStart . The
machine will feed an envelope and depending on the depth of the
envelope, will automatically select the fold type – Single or C fold.
If the envelope depth cannot be accurately determined, the machine
will stop and request you to enter the measurement manually.
A Trial Piece is automatically produced, enabling you to check the
job and to allow the machine to calibrate itself for the material being
run.
During this process, if the material in any of the feeders is too
heavy, the Double Detect for the relevant feeder(s) will be turned off
automatically. This will be indicated by a message on the display.
The machine will ask if the Trial Piece is OK.
If the Trial Piece is OK, select
Yes and follow the instructions in the
section ‘Saving a SwiftStart™ Job’ below.
If the Trial Piece is NOT OK, select
No and follow the on-screen
instructions to correct the error. You can adjust the address position,
fold panel length and/or the envelope stop position. The envelope
stop position will rarely need adjusting - for more information, see
page 6-15.
Saving a SwiftStart™ Job
After confirming a Trial Piece is OK, you will be given the option to
save the current SwiftStart™ setup as a Job Definition for recall in
future. This function requires Supervisor level access (see page 4-2).
If you do NOT save the SwiftStart™ setup, it will only be retained
while you are running the current job. If another Job Definition is
selected or if power is turned off, the SwiftStart™ settings will be lost.
Automatic Processing
Whether you have chosen to save the SwiftStart™ job or not, you
can now begin automatic processing in the normal way:
Press the Start key to begin automatic operation.
The machine will operate until either material runs out or the Stop
key is pressed.