3-18
Pitney Bowes DA500/DA550 Operator Guide
3 • DA500/DA550 Basics
9. Print a Test Piece
1. Make sure material is loaded properly. (Or you can
use a single test piece if you'd like to check your
setup adjustments.)
2. Turn the printer ON. The On/Off switch is located
on the interface panel at the rear of the machine.
Wait for the printer to finish its startup routine and
for the "ON LINE" screen to appear on the LCD.
3. Press the On Line button on the printer control
panel until the LCD display reads OFF LINE.
4. Press the "Test Env." button. A single envelope will
feed and a sample address should print.
5. Check the print quality. If it's not what you want,
adjust the media thickness lever (page 3-15) as
required and run another test piece by pressing the
Test Env. button on the interface panel at the rear
of the machine.
Setting Up A
Job
(continued)
When you're satisfied with the setup adjustments, you're
ready to run the job. The next chapter explains use of the
printer with your computer.
Test Env.
On Line
Display
