Pitney Bowes DA500/DA550 Operator Guide
3-13
DA500/DA550 Basics • 3
Once your printer is set up, you can load material and
make a test print. Avoid misfeeds by following these
precautions:
1. Make sure the input area is free of dust and other
matter.
2. Take a manageable amount of material and while
holding it as shown, fan all sides of the material to
separate each piece. This step helps keep
misfeeds to a minimum.
5. Load Material
Setting Up A
Job
(continued)
3
Tamp the material on a flat surface, making sure
that the stack is square.
4
Shingle the stack as you load it into the input area.
Load envelopes so the side to be printed faces up.
Flaps should be down and oriented away from the
feed roller (flaps trailing).
5. Position the right edge of the envelopes flush
against the support plate. Begin with just a few
envelopes to start the stack and get the proper
contour, then add several more pieces. Then, add
the remainder of the stack.
NOTE: Envelope feeding is generally more reliable if
there are more than just a couple of envelopes in the
input bin.
6. Adjust the position of the feed ramp as described
on the next page.
