Pitney Bowes DA500/DA550 Operator Guide
3-9
DA500/DA550 Basics • 3
When you set the feed gap for a number 10 envelope, the
width of the envelope will fall completely under the inside
and middle H-Blocks, but only half way under the outer H-
Block.
1. In this case, remove the sliding fence, then follow
this procedure: (refer to the figure on the next
page)
1. Slide the #10 envelope over until it is under both
fingers of the outermost H-Block.
2. Lower the outer H-Block so it contacts the mate-
rial, then lock the H-Block in place.
3. With all H-Blocks locked in position, slide the
envelope back to its original position.
2. Center the Wireform under the Material by doing the
following:
1. Place a sample piece of material in the feed area,
up against the support plate.
2. Push down on the wireframe lock lever to free the
wireframe slide.
3. Center the wireframe under your sample piece of
material.
4. Pull up on the lock lever to secure the wireframe in
position.
Setup Example Using # 10 Envelopes:
Setting Up A
Job
(continued)
