3.4.1.1 Main Burner Removal and Replacement
a.
Loosen the set screw in the base of the burner casing.
b. Unscrew and remove the two hex head screws at the top of the burner.
c. Loosen the set screw on the air collar. Lift the burner and air collar up to clear the top of the
burner fitting. Remove the burner from the fryer.
d. To re-install the burner, reverse the procedure.
3.4.1.2 Changing the Main Burner Orifice
a. Unscrew the orifice with a 3/8" wrench and remove the orifice.
b. Insert the new orifice and tighten with the 3/8" wrench. Ensure the orifice is tight enough to
prevent gas leakage around the orifice.
3.4.1.3 Replacing the Heat Baffles
a. Remove the Main Burner as described in 3.4.1.1.
b. The heat baffles are located inside the heat tubes. They are attached to the rear of the baffle
supported by tack welds. Using a chisel, break away the baffle support and remove the old
baffles. Be careful not to puncture the heat tubes because this will require complete tank
replacement.
c. Insert the new baffles in the tubes in the original position. The new baffles sit in position and
do not require welding.
d. Install the main burners.
3.4.1.4 Pilot Burner Removal and Replacement
a. Unscrew the tubing nut from the pilot tubing connection at the gas valve. Disconnect the
thermopile from the connection on the gas valve.
b. Unscrew and remove the two screws that attach the pilot assembly to the fryer tank. Lift the
entire pilot assembly out of the fryer.
c. To replace the pilot assembly, reverse the procedure.
3.4.1.5 Pilot Orifice Replacement
a. Remove the pilot assembly as described in 3.4.1.4.
3-5