2. Press the zero (0) product key. The display will change to show "SELECT".
3. Next press the two (2) product key. The display will indicate "SET PASS".
4. To turn the password requirement on or off press the zero (0) product. When the display
indicates "NO PASS" a password is not required to enter the program mode. A display of
"PASS RERQ" indicates that a password is required to enter the programming mode.
5. To enter a new password (or display the current password), press the Program key . The
display will change to display the current password "PASS####" where the current password
would display in the place of the
####.
6.
While the "PASS####" is being displayed you can change the password. Use the key pad
to enter any four numbers. After the new password has been entered (or to exit viewing
the current password) press the program key to return to the program mode.
7. To exit the programming mode press the program key again.
2.3.2.3 Beeper Volume
To set beeper volume, follow the procedure below:
1. Press the program key and enter the password (if a password is programmed). If you
are still in the low level programming mode from a previous procedure you will not need to
enter the password.
2. Press the zero (0) product key. The display will change to show "SELECT".
3. Next press the three (3) product key. The display will change to indicate "VOLUME #". The
# will be replaced with the current setting for the beeper. There are three settings for beeper
volume, one (1) being the softest and three (3) the loudest.
4. To toggle through the beeper volumes press the zero (0) product key. Each of the volume
settings will be displayed as the zero (0) key is pressed and the beeper will sound to provide
an example the volume.
5.
After selecting the desired volume, (or to exit viewing the current volume setting) press the
program key to return to the program mode.
5. To exit the programming mode press the program key again.
2-9