Piper Cherokee LANCE, Service Manual

Page: 765 / 854

PIPER CHEROKEE SIX / LANCE SERVICE MANUAL
03/27/08 III - INSPECTION
4D7
TABLE III-II. INSPECTION REPORT - PA-32R-300
Refer to Notes 1, 2, 3, and 4 before performing the following inspections.
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
A. PROPELLER GROUP
WARNING: USE EXTREME CAUTION WHEN ROTATING PROPELLER BY
HAND; PROPELLER MAY KICK BACK. PRIOR TO ROTATING
PROPELLER ENSURE BOTH MAGNETO SWITCHES ARE OFF
(GROUNDED). IF MAGNETOS ARE NOT GROUNDED,
TURNING PROPELLER MAY START ENGINE.
1. Inspect spinner and backplate for cracks, dents, missing screws,
and security ............................................................................................................
O O
2. Inspect blades for nicks and cracks........................................................................ O O
3. Inspect for grease and oil leaks .............................................................................. O O
4. Lubricate propeller per Lubrication Chart, Section II............................................ O
5. Inspect spinner mounting brackets for cracks and security ................................... O
6. Inspect propeller mounting bolts for security and safety.
If safety is broken, re-torque and safety ................................................................
O
7. Inspect hub parts for cracks and corrosion. (See Note 25.) .................................. O
8. Rotate blades of propeller and check for
tightness in hub pilot tube ......................................................................................
O
9. Inspect complete propeller and spinner assembly for security,
chafing, cracks, deterioration, wear, and correct installation.................................
O
B. ENGINE GROUP
WARNING: IF MAGNETOS ARE NOT GROUNDED, TURNING PROPELLER
MAY START ENGINE. USE EXTREME CAUTION WHEN
ROTATING PROPELLER BY HAND; PROPELLER MAY KICK
BACK. PRIOR TO ROTATING PROPELLER ENSURE BOTH
MAGNETO SWITCHES ARE OFF (GROUNDED).
NOTE: Read Note 5 prior to completing this group.
1. Remove engine cowling and inspect for internal and external damage ................. O O
2. Clean and inspect cowling for cracks, distortion, and loose
or missing fasteners................................................................................................
O
3. Drain oil sump........................................................................................................ O O
4. Clean suction oil strainer at oil change; inspect strainer for foreign particles....... O O
5. Clean pressure oil strainer or change full-flow, cartridge-type, oil filter
element; inspect strainer or element for foreign particles. (See Note 6.)...............
O O
6. Inspect oil temperature sender unit for leaks and security..................................... O
7. Inspect oil lines and fittings for leaks, security, chafing, dents, & cracks ............. O O
8. Clean and inspect oil radiator cooling fins............................................................. O
9. Fill engine with oil per information on cowling
or in Lubrication Chart, Section II .........................................................................
O O